There are a few ways to get resin out of a pipe. One is to scrape it out with a knife or other sharp object. Another is to use a solvent like acetone or alcohol to dissolve the resin.
How To Get All Your Resin
- Place the pipe over a bowl or container
- Cover the bowl or container with plastic wrap
- Secure the plastic wrap around the pipe with a rubber band
- Put the bowl or container in the freezer for at least two hours, or until the resin is hard
- Remove the bowl or container from the freezer and take off the plastic wrap
- 6 Use a dull knife to scrape off the resin from the inside of the pipe
-What is the Best Way to Get Resin Out of a Pipe
If you’ve ever tried to clean a pipe and failed miserably, you’re not alone. Resin is the sticky, gooey byproduct of smoking that can build up in your pipe over time, making it difficult (if not impossible) to clean. But don’t despair – there are a few methods you can try to get that resin out once and for all.
The first method is probably the most obvious: simply soak your pipe in alcohol. This will help break down the resin and make it easier to remove. Just be sure to use a strong alcohol like vodka or everclear – weak alcoholic beverages like beer or wine won’t do the trick.
Let your pipe soak for at least 24 hours before trying to scrub it clean.
If soaking doesn’t work (or if you’re just impatient), you can try using a plunger. Yes, that’s right – just like the one you use to unclog your toilet.
Cover the bowl of your pipe with the plunger and give it a few good pumps up and down. The suction should help loosen the resin so you can scrape it out more easily. You may need to repeat this process a few times before all the resin is gone.
Finally, if all else fails, you can always resort to good old-fashioned elbow grease. Grab a wire brush or another type of stiff brush and start scrubbing away at that resin until it finally gives way. It might take awhile, but eventually you’ll get rid of every last bit of residue.
Conclusion
If you’ve ever found yourself with resin-coated smoking utensils, you know the frustration of trying to get them clean. The good news is, there are a few easy ways to remove that sticky residue and get your pipes looking (and smoking) like new again.
The first step is to gather your supplies.
You’ll need rubbing alcohol, salt, and a container large enough to fit your pipe. Fill the container with rubbing alcohol, then add a handful of salt and stir to combine. Next, drop your pipe into the mixture and let it soak for at least an hour.
After soaking, remove your pipe from the alcohol and rinse it off with warm water. The resin should now be loosened and easy to remove. If necessary, repeat the soaking process until all the resin is gone.
Once your pipe is clean, give it a good rinse with hot water and allow it to air dry before using it again.
